EFI industrial printer dryer lamp

Sun, 05 Jul 2026 02:41:44 +0800

Technical Deep-Dive: Power, Voltage, and Dimensions

Let’s talk about getting the fit right. We build EFI industrial printer dryer lamps to match your machine exactly—not the other way around. Your printer calls for a certain voltage, a certain wattage, and a certain footprint. So that’s what we deliver. These lamps typically run at 400V or 230V, cranking out 2500W to 3500W of focused heat. The tube length is cut to match the dryer section, usually somewhere between 300mm and 450mm. That kind of power density is exactly what you need to flash-dry inks and coatings on high-speed lines. The voltage choice comes down to the machine’s electrical setup—400V setups cut down on current, which means smaller wiring and less stress on contactors. But here’s the catch: that much heat packed into a tight space needs serious cooling. If your printer’s airflow is weak, the lamp—and the electronics around it—will run hotter than they were designed for.

EFI Reggiani BOLT dryer element

Sat, 04 Jul 2026 02:07:40 +0800

A Direct Swap for Your KTK Oval Printer: The EFI Reggiani BOLT Dryer

You know that headache on the shop floor? The one where replacing the infrared heater on your KTK oval printing line feels like it’s going to turn into a full-blown re-engineering project. We felt that frustration, too. So, we built the EFI Reggiani BOLT to make that problem go away. This isn’t just another generic lamp. It’s a direct, one-to-one fitment. It’s designed to slide right into the same footprint on your KTK machine, matching the electrical and mechanical connections perfectly. No hassle. No guesswork.

EFI on UV Heating

EFI industrial printer dryer lamp

Technical Deep-Dive: Power, Voltage, and Dimensions

EFI Reggiani BOLT dryer element

A Direct Swap for Your KTK Oval Printer: The EFI Reggiani BOLT Dryer