A Direct Swap for Your KTK Oval Printer: The EFI Reggiani BOLT Dryer
You know that headache on the shop floor? The one where replacing the infrared heater on your KTK oval printing line feels like it’s going to turn into a full-blown re-engineering project. We felt that frustration, too. So, we built the EFI Reggiani BOLT to make that problem go away. This isn’t just another generic lamp. It’s a direct, one-to-one fitment. It’s designed to slide right into the same footprint on your KTK machine, matching the electrical and mechanical connections perfectly. No hassle. No guesswork.
The Specs, Without the Fluff
The BOLT runs on a 400V supply, which is standard for industrial lines. This setup gives you the power you need without pushing the wiring past its limit and causing it to overheat. And that 2500W rating? It’s all about packing a punch in a small space. You get a ton of heat density in a compact tube, which means it heats up fast and holds a steady temperature, even during those high-speed print runs. The tube length is also designed to match the KTK heater zone exactly, so the heat hits your substrate evenly across the whole print path.
What’s Inside? A Quick Look
We went with a shortwave infrared halogen design inside a quartz tube. Why quartz? Because it can handle rapid heating and cooling without breaking a sweat, keeping the output consistent over long, demanding runs. The coating on the outside isn’t just for looks. It helps manage the surface temperature and directs the energy where it needs to go—onto the substrate. This means less wasted heat that could end up baking the machine’s frame and electronics. And the connector? It’s a direct match for the KTK system. You wire it up the same way as the original. No custom brackets. No adapter plates. Just a clean, simple install.
What It Feels Like on the Floor
Here’s the best part. On your KTK oval printer, this means faster drying without having to slow the line down. And because it’s a drop-in replacement, the downtime for the swap is minimal. Now, there’s one thing to keep in mind. That 2500W at 400V generates a lot of heat. So, you need to make sure your machine’s cooling and ventilation are in good shape. But as long as those are up to spec, you get a heater that performs just like the original. It runs steady, it’s reliable, and it installs the same way every single time. Just what you need to keep things moving.